Dependence of grip strength on shoulder position and its implications for ergonomics practice

Grip strength (GS) variability due to positional changes in the upper extremity joints is of importance while designing workstations and work methods. This study was conducted to analyze the GS variations due to positional changes at shoulder joint when some important variables were under control. The GSs of dominant and nondominant hands were measured in eight shoulder (0°, 45°, 90°, and 135° of flexion and abduction) and standard test positions (STP). One hundred and thirteen subjects 20–30 years old completed the study. At the dominant side, no significant difference was observed in the pairwise comparisons between STP and the others. Maximum and minimum GSs were obtained in 0° abduction and 45° flexion and abduction, respectively. At the nondominant side, GSs were significantly lower (p < 0.001) in the corresponding test positions and demonstrated more variability. The findings of this study can contribute to the available knowledge to guide occupational ergonomists in their practices.     

Taxonomy of digital community currency platforms*

ABSTRACT

Community currencies are used to pay for products or services within specific groups defined by geographical boundaries or specific common interests. Financial crises, social emergence in developing countries, and increased access to digital devices have stimulated a growing number of communities worldwide to develop digital currency projects. These projects use technologies ranging from traditional plastic cards to mobile phones and blockchain technologies. Following the design science research approach, this paper analyzes digital community currencies (DCCs) by developing a taxonomy based on platform architecture, governance, transactionality and virtuality. By investigating 22 DCC platforms around the world, 4 groups were distinguished: local, proprietary, commons and cyber. The identification of these four different groups of digital community currencies allows us to better discuss the potentials and limitations of each one of them. The presented taxonomy can be useful to researchers and practitioners both to explain and to design DCC platforms. Discussing each of the emerging categories from the proposed taxonomy helps us to provide insights into DCCs, offering a new theoretical frame for investigating the particular case of digital payment platforms.     

Solid lipid nanoparticles of Annona muricata fruit extract: formulation,optimization and in vitro cytotoxicity studies

The present study was aimed to develop Annona muricata fruit extract loaded solid lipid nanoparticles (SLNs) and explore its cytotoxic potential in vitro model of breast cancers. Extract loaded SLNs were successfully prepared by high-pressure homogenization followed by ultrasonication method and optimized using 2³ full factorial design. The extract loaded SLNs were characterized using different parameters such as particle size (PS), % entrapment efficiency (EE), zeta potential (ZP) and % cumulative drug release (CDR). The SLNs formulation was optimized on the basis of software analysis with an overall desirability factor. The PS and %EE of the optimized formulation were found to be 134.8?nm and 83.26%, respectively. The optimized formulation showed a CDR of 79.83% up to 48?h. In vitro cytotoxicity efficacy of extract loaded SLNs was determined using MTT and Apoptosis assay and compared to that of a free extract. The SLNs showed a notable apoptotic effect and better efficacy to kill MCF7 cancer cells as compared to free extract. Thus, extract loaded SLNs could be an alternative dosage form which possibly controls therapeutic action with reducing side effect.     

Synthesis of Benzophenones and in vitro Evaluation of Their Anticancer Potential in Breast and Prostate Cancer Cells

Breast and prostate cancers are frequently treated with chemotherapy. Several novel chemicals are being reported for this purpose, particularly synthetic and natural benzophenones. This work reports the synthesis of substituted 2-hydroxybenzophenones through 1,4-conjugate addition/intramolecular cycloaddition/dehydration of nitromethane on key intermediate chromones. Structures were extensively studied by means of 2D NMR spectroscopy and single-crystal XRD. Their cytotoxicity was evaluated in vitro in two breast cancer cell lines (MDA-MB-231 and T47-D) and one prostate cancer cell line (PC3). The most potent compound exhibited good cytotoxic effects against the three cancer cell lines (IC₅₀ values ranging from 12.09 to 26.49 μm ) and induced cell-cycle retardation only on prostate cancer cells, which suggested that it might exert cell-type-specific effects.     

无失效数据机载多余度EWIS可靠性研究

针对高可靠度机载多余度EWIS各组成部分寿命服从指数分布但参数未知的情况，提出采用无失效数据可靠度分析方法评估EWIS的可靠度水平。通过Monte-Carlo仿真方法对连接形式为“先并联、后串联”EWIS各组成部分寿命进行抽样，利用“最小最大值”方法获得系统寿命的抽样值，用概率纸检验法初步判断EWIS寿命是否服从威布尔分布，再用Pearson拟合优度检验法判断EWIS寿命是否服从威布尔分布。结合无故障飞行时间的样本值与EWIS寿命服从威布尔分布的假设，采用无失效数据分析方法评估EWIS的可靠度水平。研究方法对机载多余度EWIS无失效数据可靠度分析有一定的贡献。     

Recent activities in the field of Nuclear Operational Management and Nuclear Safety Engineering

Recent activities in the field of Nuclear Operational Management and Nuclear Safety Engineering, the studies related to risk analysis methodology, design, and operational management, physical phenomena, and emergency preparedness and nuclear security, have been progressed. Especially, ‘risk analysis methodology’ and ‘design and operational management’ are the main categories of the field, in which more than half of published articles on Journal of Nuclear Science and Technology are related to these categories.     

The Art of Masonry

Brick masonry is not only a question of building physics, building construction and durability, i.e. sustainability, but has much to do with aesthetics and making sense, which may have been forgotten in modern architecture with its absolute lack of décor. Masonry as an art form has been scarce since the era of brick expressionism. Recently, there have been some exceptions – and thoroughly welcome. The ”Fjordenhus“ in Vejle, Denmark, is an astonishing example.     

Multiphase topology optimization with a single variable using the phase-field design method

In this study, a multimaterial topology optimization method using a single variable is proposed by combining the solid isotropic material with penalization method and the reaction-diffusion equation. Unlike ordinary multimaterial optimization, which requires several variables depending on the number of material types, this method intends to represent various materials as one variable. The proposed method combines two special functions in the sensitivity analysis of the objective function to converge the design variable into prespecified density values defined for each of the multimaterials. The composition constraint based on a normal distribution function is also introduced to estimate the distribution of each target density value in a single variable. It enables density exchange between multiple materials by increasing or decreasing the amount of a specific material. The proposed method is applied to structural and electromagnetic problems to verify its effectiveness, and its usefulness is also confirmed from the viewpoint of cost and computation time.     

Biologically Inspired Design of Context-Aware Smart Products

The rapid development of information and communication technologies (ICTs) and cyber–physical systems (CPSs) has paved the way for the increasing popularity of smart products. Context-awareness is an important facet of product smartness. Unlike artifacts, various bio-systems are naturally characterized by their extraordinary context-awareness. Biologically inspired design (BID) is one of the most commonly employed design strategies. However, few studies have examined the BID of context-aware smart products to date. This paper presents a structured design framework to support the BID of context-aware smart products. The meaning of context-awareness is defined from the perspective of product design. The framework is developed based on the theoretical foundations of the situated function–behavior–structure ontology. A structured design process is prescribed to leverage various biological inspirations in order to support different conceptual design activities, such as problem formulation, structure reformulation, behavior reformulation, and function reformulation. Some existing design methods and emerging design tools are incorporated into the framework. A case study is presented to showcase how this framework can be followed to redesign a robot vacuum cleaner and make it more context-aware.